PLANET VIP-281SW - Manual (Page 33)

4. If you see the wireless client in the list, WPS-PBC setting is successful.
- PIN (as register) setup step:
1. Select Config Mode: “Registrar” on Router.
2. Fill the PIN code of the other device (as Enrollee that support WPS-PIN setting) into the “configure
via Client Pincode” of Router.
3. Click the PIN buttons on Router and the other device in 2 minutes.
4. If you see the wireless client in the list, WPS-PIN setting is successful.
- PIN (as Enrollee) setup step:
1. Select Config Mode: “Enrollee” on Router.
2. Fill the PIN code of Router into the other device (as Registrar).
3. Click the PIN buttons on Router and the other device in 2 minutes.
4. If you see the wireless client in the list, WPS-PIN setting is successful.
** As the figure as above, just change two roles.
- 33 -