PLANET UMG-2000 - Manual (Page 38)

38
4.4 Creating a User Account
To create a new user account, click the “User” tab in the “User” screen. This screen allows
the administrator to create a new user profile with specified service privileges.
USER ACCOUNT:
This section lists all the available settings of the user profile:
User name: Specifies a user name. All user related IT services will be created
based on this name. It cannot be changed once set.
Full Name: Specifies the user’s full name.
Password: Specifies the user’s access password. This password will be applied
to all the user related services, too.
Confirm password: Confirms and verifies the entered user password.
Account Type: Specifies either a common user or admin user privilege. The
user with the admin privilege can access the GUI management pages to
manage the UMG-2000 Series except the storage service.
Account Status: Indicates whether the user account is in an active or
suspended state. Active: all user subscribed IT services can be optionally
enabled. Suspended: all user subscribed IT services are disabled.
Department: Indicates a proper group or department for the user. You can create
a new group or department by clicking the “Group” tab from the “User”
screen.
User ID: Specifies a unique user identifier for the user. The default value is
recommended.
USER SERVICES:
This section lists all the available settings of the user services:
Email: Allows or denies user Email services.
PPTP VPN: Allows or denies a user’s VPN remote access privileges.
Private Storage: Allows or denies a user’s local storage access.
Storage Quota: Specifies the maximum user quota.
IP PBX phone privilege: Allows or denies a user’s VoIP phone access.
Disable: Denies a user’s VoIP phone access.
Local: Allows the user to dial a local external phone.
National: Allows the user to dial a national external phone.
International: Allows the user to dial an international external phone.
Extension: Specifies the VoIP phone number of the specific user which starts
with the local dial prefix. It must be specified if the IP PBX phone privilege
is not disabled and it cannot be changed once applied.
Voice Mail Password: Specifies the password that is used to access the voice
mail. It must be specified if the IP PBX service is enabled.