Eltax AVR-900 - Manual (Page 12)

12
REMOTE CONTROL UNIT
By using the provided remote control unit, the receiver
can be controlled from your listening position.
To use the remote control unit, point it at the REMOTE
SENSOR window of the receiver.
Notes:
z
Even if the remote control unit is operated within the
effective range, remote control operation may not
work if there are any obstacles between the unit and
the remote control.
z If the remote control unit is operated near other
products that generate infrared rays, or if other
remote control devices using infrared are used near
the unit, it may operate incorrectly.
z To simplify explanation, this manual refers to names
of buttons and controls on the front panel, making no
mention of the use of remote control unit.
z The power is turned on/off (standby) by pressing the
POWER button on the remote control unit in standby
mode.
Precautions concerning batteries
z
Be sure to insert the batteries with correct positive+
and negative – polarities.
z Use batteries of the same type. Never use different
types of batteries together.
z Do not heat or disassemble batteries and never
dispose of old batteries by throwing them in a fire.
BATTERY INSTALLATION
1. Remove the battery compartment cover.
2. Insert two “AAA” dry batteries.
Make sure that the batteries are inserted with their
positive “+” and negative “-” poles positioned
correctly.
3. Close the cover until it clicks.
If the distance required between the remote control
unit and main unit decreases, the batteries are
exhausted. In this case, replace the batteries with
new ones.