Eltax AVR-900 - Manual (Page 14)

14
REMOTE CONTROL INFORMATION
1. Power
Push this button to turn the unit into standby mode, push
it again to turn off the unit.
2. Mute
Press this button to mute the sound, push again to cancel
the mute function.
3. Test Tone
To balance speakers in Dolby Digital or Dolby Pro Logic
mode.
4. Input Mode
To select input modes: ANA, OPT, and COAX when
using digital in.
5. Display
Press this button to display the state of input source. And
when listening to the FM broadcasting with RDS, press
this button to show PS, PTY, RT and RT.
6. Input Selector buttons
7. Memory
Press it to store the broadcast station as a preset.
8. PTY Search
In FM state, press this button, the current program type
appears on the display, using TUNING +/- to select the
program type you desire.
9. Station +/-
Press these buttons to select a preset channel during the
tuner mode.
10. Tuning buttons
- Tuning +/-: Tuner frequency up and down.
- Band: Press this button to alternate between FM and
AM.
- Auto/Manual: This button is used to select AUTO or
MANUAL tuning for AM and FM stations. Press once to
set to AUTO again for MANUAL.
- ST/Mono: Press this button to alternate between Stereo
and Mono mode when listen to FM broadcast.
11. CH Select
Select channels by pushing this button, then use volume
key to balance speakers.
12. Direct In
Press this button to select the 6.1 analogue input.
13. LFE Trim
Under the Pro Logic 5.1CH or DTS 5.1CH mode, press
this button and adjust the volume to set the Low
Frequency output level
14. Volume +/-
Press these buttons to decrease or increase the volume.
15. Bass
Press this button for Bass adjustment, then press +/- key
to adjust the level.
16. +/-
These keys are used for SPK SETUP and DELAY TIME,
Treble and Bass adjustment.
17. Treble
Press this button for Treble adjustment, then press +/- key
to adjust the level.
18. Delay Time
Press this button to set the delay time for the Dolby
digital/Dolby Pro Logic modes.
19. SPK Setup
Under PRO LOGIC II or Digital state, it can change the
desired Speaker Setting shown on the display.
20. Dynamic
Press this button repeatedly to reach your desired
compression dynamic range.
21. DTS/Dolby Digital
When playing 5.1CH source, and while you are enjoying
Stereo, push this button to playback source in
DTS/DOLBY DIGITAL.
22. Surround Back
Push this button to turn on or off the surround back
output.
23. Surround Mode
Selects surround modes: Theater, Hall, Passthru, Movie,
Music, and Room.
24. Pro Logic IIx
When receiving Analog/digital PCM signal or 2CH Pro
Logic, turn on this button then the playing is under analog
5.1CH state.
25. Stereo
With the unit in the STEREO mode, only front left and
front right speakers and Woofer are working.
26. SUB On/Off
Push this button to turn on or off the subwoofer output.