MIDEA MWA12CR71 - Manual (Page 14)


Page 14

NOTE
The top rail hardware and the
following Fig. E, Fig. F and Fig. G
are not applicable to the units over
10,000 Btu/h.
2. PREPARE AIR CONDITIONER
Before installing unit, the top rail must be assembled on the unit for models with a
capacity of less than 10,000Btu/h.
CAUTION
When handling unit, be careful to
avoid cuts fro
m sharp m etal edges and
alu m inu m fins on front and rear coils.
Packaging
Top Rail
Fig. E
Mounting Hardware
3/4” (or 1/2”)
Screws
(7)
Lock Frame
(2)
Sash Lock
(1)
Window sash
seal foam
(1)
Top Rail Hardware
Top Rail
(1)
3/8” Screws
(4)
1. PREPARE THE WINDOW
Lower sash must open sufficiently to allow a clear vertical opening (H) of following
size (see Table 1). Side louvers and the rear of the AC must have clear air space to
allow enough airflow through the condenser, for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
NOTE
Save Carton and these Installation Instructions for future reference. The carton is the
best way to store unit during winter, or when not in use.
A: Remove the air conditioner from the
carton and place on a flat surface.
B: Remove top rail from the bottom of the
packaging material as shown in Fig. E.
Ins
tallation
Ins
tructions