MIDEA MWA12CR71 - Manual (Page 17)


Page 17

Ins
tallation
Ins
tructions
6. To secure lower sash in place, attach right angle sash
lock with 3/4” (19mm) or 1/2” (12.7mm) screw as
shown (Fig. 8).
7. Cut window sash seal foam and insert it in the space
between the upper and lower sashes (Fig. 9).
Fig. 8 Fig. 8
Fig. 9
FOAM SEAL
Fig. 9
SASH
1-1/2"min
(38 mm)
Fig. 10
Board thickness
as required, for
proper pitch to
rear, along entire
sill. Fasten with
nails or screws.
Storm window
frame or other
obstruction.
Fig. 10
If AC is Blocked by Stor m Window
Re m oving AC Fro m Window
Add wood as shown in Fig. 10, or remove
storm window before air conditioner is
installed.
If storm window frame must remain,
be sure the drain holes or slots are not
caulked or painted shut. Accumulated rain
water or condensation must be allowed to
drain out.
• Turn AC off, and disconnect power cord.
• Remove sash seal from between windows, and unscrew safety lock.
• Remove screws installed through frame and frame lock.
• Close (slide) side panels into frame.
• Keeping a firm grip on air conditioner, raise sash and carefully remove
• Be carefully not to spill any remaining water while lifting unit form window. Store
parts WITH air conditioner.