MIDEA MES30S2AST - Manual (Page 20)

Rear Filler Trim Installation (optional):
Counter continues around behind
installation space - no rear filler
trim required.
Directions:
• Align filler trim mounting holes.
• Attach with the screws provided with the trim kit. No countertop behind at back of
installation space - rear filler trim
recommended.
• Attach anti-tip bracket to floor or wall.
o Wood Construction Installation: Drill
a 1/8" pilot hole where screws are to
be located.
If bracket is to be mounted to the wall,
drill pilot hole at an approximate 20°
downward angle. Screw must enter
wood.
o Masonry Construction Installation: Due
to the variety of masonry materials
that may be present at installation
site, hardware is not provided for
attaching the anti-tip bracket to
masonry. If bracket is to be mounted
to masonry or ceramic floors, attach
anti-tip bracket using two 5/16" OD
sleeve anchors (with 1/4" bolt - either hex bolt head or hex nut head)
rated for minimum 300lb tension for the masonry material present
at installation site.
FANSTEN BRACKET
(FLOOR MOUNTING ONLY)
More than
1-1/4”
Leveling leg
Floor Mount
Anti-Tip
Bracket
Wall
If there is no counter surface around the back edge of the installation
space, or if the countertop cutout is greater than 25" deep, this may
prevent the range from being installed flush to the back wall. If this
occurs, a trim kit can be installed to cover a gap up to 1 inch in width.
Contact Midea Customer Service to order a trim kit.
IM
PORT
AN
T
SAF
E
TY
INS
T
RUCTION
S
B
E
FOR
E
ST
A
RTIN
G
IN
STALL
A
TIO
N
INS
T
ALLATIO
N
P
ROCE
D
UR
E
CONFIR
M
OP
ER
AT
IO
N
TROUBLESHOOTING
SAF
ET
Y
D
EFINITION
S
20