MIDEA MES30S2AST - Manual (Page 25)

Directions:
• Use tape measure to measure from the floor to the top of the counter
top at all four corners of the installation space.
• While range is still positioned outside the installation space, adjust the
leveling leg at each corner so that the distance from the floor to the
underside of the cooktop edge matches the dimensions measured in
the installation space.
• Using two people, move range into its final installation location, being
careful not to damage countertops, floor, or appliance.
o IMPORTANT: Do not move unit by pushing or pulling on the door or
control panel. Do not lift by the cooktop edges. Push, pull, or lift only
on the body or structural areas, such as oven, oven face, or back
corners of range.
o Be careful not to pinch or kink the gas or electrical connections.
If unit does not move in smoothly, check for obstructions. Do not
attempt to force the unit into position.
o Dampening the countertop where the cooktop overhangs with
soapy water may allow the range to slide into position more smoothly.
o The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT rest directly on the countertop or else it could cause
damage to the cooktop voiding the warranty.
• Check that the gas supply line is not damaged.
• Check to make sure the back leg of the range
has engaged properly into the anti-tip bracket.
If visual inspection is not possible:
o Slide range forward
o Confirm anti-tip bracket is securely attached
to floor or wall in correct position according
to installation instructions.
o Fully slide the range back against the wall so
that leveling leg engages with anti-tip bracket.
IM
PORT
AN
T
SAF
E
TY
INS
T
RUCTION
S
B
E
FOR
E
ST
A
RTIN
G
IN
STALL
A
TIO
N
INS
T
ALLATIO
N
P
ROCE
D
UR
E
CONFIR
M
OP
ER
AT
IO
N
TROUBLESHOOTING
SAF
ET
Y
D
EFINITION
S
25