Roland Web Presentation Dock - Manual (Page 11)

11
Configuring the Settings (UVC-02 Setup Tool)
Returning to the Factory Settings
(Factory Reset)
Here’s how you can return the settings of the UVC-02 to their factory-
set state. If the unit does not operate as described even though
you’ve followed the steps in the manual, try executing a factory reset.
NOTE
When you execute a factory reset, all of the settings you made
are lost
1
Select by clicking the [SYSTEM] tab.
2
Click the [FACTORY RESET] button.
A confirmation dialog box opens. To cancel, click the [CANCEL] button.
3
Click the [OK] button.
The factory reset is executed.
Updating the UVC-02 System Program
Use the Setup Tool to update the system program of the UVC-02.
Checking the version number
1
Select by clicking the [SYSTEM] tab.
2
In the FIRMWARE box, check the current version listed.
* You don’t need to update the firmware if the latest version is
already installed.
Updating
1
Download and install the latest version of Setup Tool.
The latest version can be found on the Roland website as listed below.
https://roland cm/uvc-02/
2
Connect the unit to your computer with the included
USB cable.
A screen like the one shown below appears.
MEMO
5 You can click the [SKIP] button if you want to keep using the
unit without updating.
5 The [SKIP] button may not appear if there has been a major
change in specifications.
3
Click the [UPDATE] button.
The update begins.
The settings of the UVC-02 are automatically saved to your computer
during the update.
The UVC-02 button blinks during the update.
NOTE
Never turn off the power while the update is in progress
(the [TALK] button blinks red while the UVC-02 is
updating). Failure to observe this may cause the UVC-02
to malfunction.
Once the update is completed, “FIRMWARE Update Complete.” appears
on the screen, and the [AUDIO OUT], [TALK] and [VIDEO OUT] buttons
on the UVC-02 light up blue.