Edimax Technology PS-1206MF - Manual (Page 59)

48
7. Troubleshooting
1. The MFP Server is not found even after searching with the “MFP Manager”.
„ Check if the power adapter and the network cable are connected to the
MFP Server properly.
„ Check if the LAN and Ready LEDs are turned on.
„ Check if the IP Address of the MFP Server is in the some network
segment as your computer.
- If you are not sure of the IP Address setting of the MFP Server, please
check the TCP/IP setting of the MFP Server from the “Server
Manager”.
2. How do to change the IP Address of the MFP Server?
„ A DHCP Server is installed in the network
If a DHCP Server is installed, you can let the MFP Server get an IP
Address from the DHCP Server automatically.
1. Open “Server Manager” and then select “TCP/IP” setting.
2. Select “Auto IP” and click “Save”.
3. Reboot the MFP Server.
„ Set up the IP Address Manually
1. Open “Server Manager” and then select “TCP/IP” setting.
2. Select “Static IP” and enter the IP Address and Subnet Mask that
match your computer. Click “Save”.
3. Reboot the MFP Server.
Note: Setting a static IP Address for MFP Server is recommended since
DHCP assignment may dramatically change the IP Address of the MFP
Server.
3. A user stays connected to the MFP Server.
„ Contact the current user and ask to disconnect the device.
„ If the user forgets to disconnect the device, you can ask the
administrator to release the device.