Sony PCK-LG3 Glass Screen Protector for a7R V - Manual (Page 12)

12
Setting the range of UP/DOWN movement
When you turn the camera to the right or left beyond the
90° with the camera pointed downward by 25°, the
camera may be caught on the lens, depending on the zoom
position of the lens.
D-ZOOM (digital zoom)
You can set digital zoom to ON or OFF. When set to OFF,
digital zoom does not operate, and only optical zoom is
available. When set to ON, digital zoom takes over after
optical zoom reaches MAX (12×). Up to 144× can be
zoomed digitally.
When digital zoom is available, the resolution decreases.
SYSTEM Menu
IR-RECEIVE (infrared signal reception)
When this is set to OFF, the camera does not receive the
signal from the supplied infrared remote commander.
Be sure to keep it set to ON when you use the supplied
infrared remote commander.
You cannot set IR-RECEIVE to OFF when you operate
the menu using the supplied infrared remote commander.
To set it to OFF, use the appropriate VISCA command.
DISPLAY INFO
When this item is set to ON, the message automatically
appears for about 3 seconds on the monitor screen, when
you perform the following operations using the supplied
infrared remote commander.
Note
+25°
– 25°
0°
Note
Message Remote control operation
PRESET n: OK
“n” is a preset position
number of the infrared
remote commander,
between 1 and 6. You have stored the camera
settings to POSITION 1 to 6.
RECALL n: OK
“n” is a preset position
number of the infrared
remote commander,
between 1 and 6. You have read the camera
settings stored in POSITION 1
to 6.
RESET n: OK
“n” is a preset position
number of the infrared
remote commander,
between 1 and 6. You have reset the camera
settings stored in POSITION 1
to 6 to the default settings.
ONE PUSH WB: OP During the white balance
adjustment in the ONE PUSH
white balance mode, the
message blinks on the
screen.
ONE PUSH WB: OK When white balance
adjustment is correctly
performed in ONE PUSH
white balance mode, this
message appears on the
screen.
ONE PUSH WB: NG If white balance adjustment is
incorrectly performed in ONE
PUSH white balance mode,
this message flashes on the
screen.