Sony SRG-120DU USB 3.0 Full HD PTZ Camera - Manual (Page 35)

35
1) Body-pack transmitter (UTX-B40) / hand-held microphone (UTX-M40) / plug-on transmitter (UTX-P40) only
2) Body-pack transmitter (UTX-B40) / plug-on transmitter (UTX-P40) only
3) Portable diversity tuner (URX-P40) only
4) Body-pack transmitter (UTX-B40) / portable diversity tuner (URX-P40) only
5) Body-pack transmitter (UTX-B40) / plug-on transmitter (UTX-P40) / portable diversity tuner (URX-P40) only
6) Hand-held microphone (UTX-M40) only
The attenuator cannot
be set. The GAIN MODE menu is set to AUTO GAIN, or
the INPUT LEVEL menu is set to LINE. Change the GAIN MODE menu and INPUT
LEVEL menu settings.
There is sound
interruption or noise. The channel setting on the transmitter is different
from that on the tuner. Use the same channel setting on both the
transmitter and tuner.
Two or more transmitters are set to the same
channel. Two or more transmitters cannot be used on the
same channel. Refer to the frequency list stored
on the supplied CD-ROM, and reconfigure the
channel on each transmitter.
The transmitters are not set to the channels within
the same channel group. The channel plan is set so that no signal
interference occurs when two or more transmitters
are used simultaneously. Set each transmitter to a
different channel within the same channel group.
Adjacent channels are being used. Use the channels separated by at least two
channels (250 kHz).
The RF indicator on
the tuner lights up
even when the
transmitter is off. Jamming radio waves are being received. Set the channel on the tuner to a channel for
which the RF indicator does not light, or use the
Clear Channel Scan function to switch to a
channel without interference. Then, set the
transmitter to the same channel as the tuner.
If using two or more transmitters, change to a
channel group that is not affected.
The transmitter
channel cannot be set
with infrared
transmission.
1)
The infrared receptor on the transmitter is too far
from the infrared transmission port on the tuner. Reduce the distance between the infrared
receptor on the transmitter and the infrared
transmission port on the tuner to within about
20 cm (8 in.).
Interference from infrared communications
between other devices or from direct sunlight is
present. The transmitting distance is reduced when
interference from strong sunlight, for example, is
present. Place the transmitter and tuner as close
to each other as possible.
The transmitter
channel cannot be set
via NFC
communication. The N-Marks of both units are not facing each
other, or they are too far apart. Or there may be
some metallic object between the N-Marks. Place the N-Marks approximately 5 mm from each
other. Make sure there are no metallic or other
objects near them.
The grip is open.
6)
Symptom Cause Solution