Emprex PD-7001 - Manual (Page 19)

Troubleshooting
7. Memory Play function: This player has memory play function. If you reset or put the
previous disc into the tray after reopening the tray, the player will continue to play
from the point interrupted last time. If you do not want to have this function you can
select the OFF.
Before requesting service for this DVD player, please check the items below for a
possible cause of the problem you are encountering . Some simple checks or a minor
adjustment on your part may eliminate the problem and restore the proper operation.
1. Power
2.Picture
Picture distortion Ø
Need to clean the disc.
Ø Picture does not fit TV screen
3. Sound
No Sound Ø
(c).When the unit is in System Setting/Program Menu, press Setup/Prog to
exit the System Menu/Program menu, or press Play to return to the normal
playback mode
4.Operations
Ø The remote control does not work properly.
(a).Using remote control near the unit. Aim the remote control at the remote
sensor of the unit.
(b).If the batteries in the remote control are dead, please replace batt-
eries with new ones.
Ø Disc Playback Failure
Ø The player fails to play from the beginning
Ø Stops playing automatically
Some discs have recorded the pause automatically command in the original
recording. The unit will stop playing automatically at the segment where the
command is recorded.
32 33
Ø No power
If the battery is dead, please recharge the battery or connect the unit to the
adapter.
The battery life is between 3 and 4 hours depending on your usage. A Low battery
warning will be displayed about five minutes, after which the unit will automati-
cally switch off.
Check if the AC power cord has been connected correctly or if the battery is in place.
The images may not fill up the whole TV screen even after the mode has been set.
This is because the DVD images are fixed in width
.
(a).If the unit is being played in slow or pause mode, press Play to return to normal
playback.
(b).If the unit is played in 8x, 16x, or 100x mode, press Play to return to the normal
playback speed.
(d).If the unit is Muted, press Mute again to enable the normal sound play.
(a).No disc is inserted. (No disc symbol appears on the screen). Please insert
your disc. It is possible that the disc is dirty. Please clean the disc.
(b).There could be humidity in the unit. Power on the unit for 30 minutes with-
out playing any discs.
(a).The play mode is in the Program, Random, Repeat or Repeat A-B mode.
Press the relative functions again to restore the normal play mode.(Please
refer to the advanced operations chapter for detailed instructions.)
(b).While the DVD Title/Chapter or DVD setup menu is displayed on the TV
screen directly, or while playing Video CD that includes PBC function, the
setup menu is displayed on the TV screen.