Emprex PD-7001 - Manual (Page 4)

3 4
1.1 1.2
Note: Remember to turn your TV on and
tune it to the corresponding input
channel on your TV .
AUDIO/OPTICAL OUT
VIDEO OUT
Make sure the battery is properly attached to the player.
Connect the output from the power adapter to the DC IN port on the player(Figure
1.1) and the LED will light up.
This LED will turn to green once the battery is fully charged.
When charging the battery for the first time, please charge for at least 12 hours.
Battery Warning Information: When the battery level is low, it will show a low
battery warning on the LCD screen
. (Figure1.2)
1. Connect the output from the power adapter to the player's DC IN socket.
2. Connect the power adapter's supply cable to a AC power outlet.
Attaching the battery
2.Place the player centered on top of the battery so that the battery s locating pegs
fit into the fixing holes( )on the underside of the player.
3.Slide the player back onto the battery until it clicks into place.
1.Turn the player over, with the rubber pads facing up.
2.While pushing the removal tab down, slide the battery in the opposite direction.
The battery will slide right off.
Removing the battery
Note: If the power adapter is plugged in, the player will function even if the battery
is not attached.
Note: Contact the appropriate local governmental office or your current waste re-
moval provider for assistance in determining the correct battery disposal
method in your area.
1.Lay the battery down flat as shown in the illustration.