England's Stove Works TRANQUILITY 17VL - Manual (Page 24)

Page | 24
REPLACEMENT PARTS LIST
Diagram
No.
Description Part No. Per Unit
1 Air Control Slider AC‐17ACS 1
2 Outside Air Adapter AC‐17OAA 1
3 Right Vermiculite Panel AC‐17RBR 1
4 Left Vermiculite Panel AC‐17RBL 1
5 Rear Vermiculite Panel AC‐17RBB 2
6 9" x 4" x 1.25" Firebrick AC‐SB 4
7 Top Vermiculite Baffle AC‐17RBT 1
8 Door Gasket [5/8" dia HD] AC‐DGKNC 1
9 Window Gasket AC‐GGK 1
10 Ceramic Glass Panel AC‐G40 1
11 Window Retaining Brackets AC‐GS16 2
12 Cast Iron Door CA‐16 1
13 Secondary Tube (Front) AC‐17BTF 1
14 Upper Refractory Baffle AC‐17URBVL 1
15 Secondary Tube (Rear) AC‐17BTR 1
Not Shown Large Spring Handle AC‐SH (Brass) 1
AC‐SHN (Nickel)
Not Shown Air Control Spring Handle AC‐SH4 (Brass) 1
AC‐SH4N (Nickel)
OPTIONAL ACCESSORIES
AC‐16 Convection Blower
The Tranquility wood stove was also designed for use with a convection blower for
additional heat circulation. The stove is constructed with rear and top convection channels
which allow the room air blower to pick up heat from the hottest regions of the stove and
transfer it into the home. The mounting screws for the blower are installed into the rear
convection channel at the factory; mounting the blower only requires a 5/16” open end or
socket wrench to remove these screws and install the blower. When routing the power cord,
take care to keep away from hot areas of the unit and remember that this blower is for use only
with the stove. Please see the diagram below for clarification on the room air blower
installation.
(4) 5/16” head, self tapping
screws (pre‐installed in unit).
Warning
Disconnect the
electrical power from
the fan before
installation.
The optional heat circulation blower on this stove requires periodic lubrication; this lubrication
should be performed no less than every three months of normal operation. To properly lubricate the
blower, use an eye dropper or similar dispensing device to drip 5-7 droplets of SAE 20 oil into the
oil port on the side of the blower motor.