Enviro Bistro 4500 C-10124 - Manual (Page 10)

10
S
IDE
S
HELF
A
ND
U
TENSIL
R
ACK
I
NSTALLED
O
NTO
C
ART
A
SSEMBLY
:
Components Required:
● Rolling cart with engine
● (2) Shelf gussets ● Side shelf
● (12) 1⁄4” x 1⁄2” stainless steel bolts ● (12) 1⁄4” stainless steel lock washers ● (6) 1⁄4” stainless steel nuts
● Utensil rack ● Side shelf top or corian cutting board
Figure 18
The side shelf can be installed on either side but if a side burn is to be installed as well, the side shelf must be
installed on the left side (see Figure 18).
1. Attach the two (2) shelf gussets (formed edges pointing in) onto the front and rear of the left side panel, using
four (4) bolts and four (4) lock-washers, through the inside of the side shelf into pre-threaded inserts already
installed in the side of the cart.
2. Place the side shelf on the shelf gussets and install four (4) bolts, four (4) lock-washers, and four (4) nuts through
the holes in the bottom of the side shelf and the corresponding hole at the top of the shelf gussets. DO NOT
TIGHTEN THESE BOLTS ENTIRELY, THIS WILL HELP WITH ALIGNMENT FOR NEXT STEP.
3. Install two (2) bolts and two (2) lock-washers through the side of the side shelf into the pre-threaded inserts
already installed in the side of the engine assembly.
4. The utensil rack can be installed on the side of the side shelf or directly onto the side of the engine. If it is to
be installed onto the side shelf, place the two (2) bolts through the holes on each end of the utensil rack then
through the side of the side shelf. Use two (2) lock-washers and two (2) nuts to hold the bolts in place.
5. Using a 1⁄4” socket or nut driver and a 5 / 32 ” Allen key tighten all the fasteners.