Panasonic AV-UHS500 12G-SDI/HDMI UHD 4K Compact Live Switcher - Manual (Page 107)

107
Input/output signal settings
Setting the HDMI output signals
Set the HDMI output signals of the standard output (HDMI
OUT) and the HDMI output signals if the HDMI output unit
(optional) has been connected.
1 On the Output sub menu, use [F2] to select the output
to be set using the Select item.
 Refer to “Output signal settings”.
2 From the Output sub menu, use [F4] to set the output
color range in the Color Space item.
HDR BT.2020 High dynamic range, color range output is
Rec.2020.
HDR BT.709 High dynamic range, color range output is
Rec.709.
SDR BT.709 Standard dynamic range, color range output
is Rec.709.
3 Use [F1] to display the Assign sub menu.
4 Use [F2] to set the type of output signal using the
Source item.
PGM An image provided with the wipe, mix, key,
downstream key or other effect is output at
the switcher’s main line output.
PVW This is the preview output that enables the
next operation to be checked before it is
executed.
CLN The clean signal (the image resulting when
the key, downstream key or other effect
has been removed from the PGM signal) is
output.
ME PGM ME PGM signals (images without the
downstream key effects) are output.
AUX1 to 4 The signals selected by the 4 lines of AUX
buses (AUX1 to AUX4) are output.
MV1, MV2 The multi view display signals are output.
Multiple input signals and output signals are
reduced in size and output to one screen.
KeyOut The key signal is output.
The settings below are possible when an HDMI Output
Unit (optional) is connected.
5 Use [F1] to display the HDMI Output sub menu.
6 Use [F2] to select the resolution of the images to be
output using the Size item.
Auto The equipment information of the output
destination is captured by the HDMI signals,
and the images are output at the optimum
resolution.
XGA (1024 × 768) / 60 Hz
WXGA (1280 × 768) / 60 Hz
SXGA (1280 × 1024) / 60 Hz
WXGA+ (1680 × 1050) / 60 Hz
UXGA (1600 × 1200) / 60 Hz
WUXGA (1920 × 1200) / 60 Hz
WQHD (2560 × 1440) / 60 Hz
Native Same format as the system format is output.
7 Use [F3] to set the output color space in the Color item.
Auto Device information about the connection
destination is obtained via the HDMI signal,
and output uses the optimum color space
accordingly.
RGB The color space is set with the RGB format.
YUV444 The color space is set with the Y, Cb, Cr at
4:4:4. (With this method, for each 4 horizontal
pixels, 4 pixels each are sampled of the
luminance component and 2 color difference
components)
YUV422 The color space is set with the Y, Cb, Cr at
4:2:2.
(With this method, for each 2 horizontal
pixels, 1 pixel each is sampled of the color
difference components, and each pixel is
sampled of the luminance component)