Estate E-SC 1102 - Manual (Page 20)

5.4
Installing and Setting Transmitters and Receivers
Installing the Receiver
1) Locate the 5 Silver Pins on your MASTER Estate Swing board, located above
the battery.
2) Locate the white connector on the receiver.
3) Push the white connector from the receiver on the 5 pins on your FAAC board
with the dip switches of the receiver board facing away from the center of the
Estate Swing board.
Setting the Dip Switches
1) Set the dip switches on the receiver by switch-
ing them in the up, down or center position.
Record this dip switch combination
2) Slide off the battery cover of the transmitter
(located at the bottom front cover)
3) Set the dip switches in the transmitter to the
same settings as the dip switches on the receiver.
4) Repeat this for all of the transmitters.
Positioning the Antenna
Bend the antenna to go around the back of the
receiver board and down the left side of the
Estate Swing battery.
Dip switches are located under
the battery lid.