Enterasys Networks 7S4280-19-SYS - Manual (Page 102)

Memory Locations and Replacement Procedures
B-2 Mode Switch Bank Settings and Optional Installations
module names, are reset to the factory default settings. Once the module resets, you can either
use the factory default settings or reenter your own parameters.
• Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Figure B-1 Mode Switch Location on the NAC Controller PEP (2S4082-25 shown)
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory
Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and
replace these memory modules. If you have questions concerning the replacement of either
memory module, refer to “
Getting Help ” on page xviii for details on how to contact
Enterasys Networks.
Location of Memory Modules
The location on the main board of the DRAM SIMM and DIMM for both the 2S4082‐25 and the
7S4280‐19 are the same.
Figure B‐2 shows the locations of the DRAM SIMM and DIMM on the
main board of the 2S4082‐25.
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.
1 Mode switch bank