Enterasys Networks 7S4280-19-SYS - Manual (Page 104)

Memory Locations and Replacement Procedures
B-4 Mode Switch Bank Settings and Optional Installations
Installing the DIMM
To install a DIMM, refer to Figure B‐4 and proceed as follows:
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down
between the connector arms. Then release the two connector arms to lock the DIMM into
place.
Figure B-4 Installing the DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
1 DIMM 3 Connector arms
2 Connector fingers 4 DIMM alignment notches (2)
А
Б
В
Г
Г
В