Enterasys Networks 7S4280-19-SYS - Manual (Page 31)

NAC Controller PEP Network Requirements
Enterasys NAC Controller Hardware Installation Guide 2-3
Fan LED
See Figure 2‐2 for the location of the fan LED. Table 2‐2 describes the different states of the fan
LED.
Figure 2-2 Fan LED
NAC Controller PEP Network Requirements
This section provides information concerning the network requirements that must be met to
ensure a satisfactory performance from the NAC Controller PEP. The information consists of the
following:
1 Fan LED
Table 2-2 Fan LED States and Definitions
LED Color Status
Green All fans are operating normally.
Amber One fan failure has occurred.
Red More than one fan failure has occurred.
Note: The fan LED status functionality requires that the NAC Controller PEP be operational. Fan
status will not be reported by the fan LED when a NAC Controller PEP is not functioning.
FAN STATUS PS1 STATUS PS2 STATUS
N1
GROUND STRAP
7C111
1
For information about... Refer to page...
Link Aggregation 2-4
10BASE-T Network 2-4
100BASE-TX Network 2-4
1000BASE-T Network 2-4
1000BASE-SX/LX/ELX Network 2-5
Note: The Enterasys Matrix DFE-Diamond/Platinum Series Configuration Guide and the Cabling
Guide referred to in the following sections can be found on the Enterasys Networks World Wide
Web site:
http://www. enterasys.com /support/manuals
Refer to “ Related Documents ” on page xvi.