Enterasys Networks 7S4280-19-SYS - Manual (Page 39)

Powering Up a Enterasys Matrix N1 Chassis
Enterasys NAC Controller Hardware Installation Guide 3-5
Figure 3-2 ESD Grounding Receptacle
Powering Up a Enterasys Matrix N1 Chassis
To power up a Enterasys Matrix N1 Chassis with ac power supplies, refer to Figure 3‐3 and
proceed as follows:
1. Plug one end of each power cord (supplied with the chassis) into the ac power sockets on the
back of the N1 Chassis. See
Figure 3‐3 on page 3‐6 for the power connections.
2. Plug each of the power cords into separate dedicated 115 Vac, 15 A receptacles.
3. Ensure that the Power LED on each power supply is green, located on the front panel of the
N1 Chassis.
4. Ensure that all fans in the fan tray unit are operating properly when power is received from
the power supply modules (fan tray LED will be green, located on the front panel of the N1
Chassis). For more information on the power supply LEDs (Power and Fan), refer to
“
LANVIEW LEDs ” on page 2‐2.
1 ESD grounding receptacle
Note: To install the NAC Controller PEP, refer to the Chapter 4 , NAC Controller PEP Installation
section for the installation instructions. Before you power up the Enterasys Matrix N1 Chassis, it is
recommended that you complete the installation of the NAC Controller PEP in the chassis.
FAN STATUS PS1 STATUS PS2 STATUS
N1
GROUND STRAP
7C111
N1 7C111 d
GROUND STRAP
N1
1
Note: For power redundancy, each of the power cords from the two power supplies must be
connected to dedicated 15-Ampere ac power circuits.