Emerson PD5500 - Manual (Page 5)

5
SETTING THE CLOCK
Make sure the unit is OFF. Press
the CLOCK SET/MEMORY
button and the hours will blink.
1
Set the correct minute using the
Tuning Up/Clock Adj.(+) FWD.
(
) and (–) REV. ( ) buttons.
4
When finished setting the hour,
press the CLOCK SET/MEMORY
button again and the minutes will
blink.
3
Set the correct hour (and AM/PM)
using the Tuning Up/Clock Adj.(+)
FWD. (
) and (–) REV. ( )
buttons.
2
When finished setting the hour,
press the CLOCK SET/MEMORY
button again and the clock will be
set.
5
When the unit is first plugged in, the time display will not be set. Set the time as follows:
NOTE:
In case the main power
supply is interrupted, the
clock will be reset unless
back-up batteries are
installed.
PD5500 O/M.QXD 7/9/01 4:35 PM Page 5