Epson 1240U - Manual (Page 15)

10
Setting Up Your Scanner
9. After the scanner software installation is complete,
the Screen Calibration utility automatically starts.
For the best results from an EPSON ink jet printer,
leave the default setting of 1.8.
If you are using a different printer or your printouts
don’t match what you see on screen, you can
change the setting. Move the slider to the right or
left until the shades of the horizontal gray stripes
appear similar. View the screen from a short
distance. The gray stripes will not perfectly blend
together; however, try to make the two tones match
as closely as possible.
10. Click OK to register the calibration setting.
You will not need to change the screen calibration again as long as you
continue to use the same monitor.
If you don’t see the Screen Calibration utility, you can access the utility as
follows: Double-click the Scanners and Cameras icon in the Control Panel.
Click the Properties button. Click the Utility tab, then click the Screen
Calibration utility icon. The Screen Calibration utility appears.
11. Click Finish to exit the Add New
Hardware Wizard.
12. Now you can install the rest of your
software (see page 19) and view your
electronic manuals (see page 23).
basics.book Page 10 Tuesday, October 24, 2000 9:53 AM