Unit 1 unit id, Unit 2 unit id, Unit 3 unit id – ELAN Home Systems V883 User Manual
Page 12: Unit 4 unit id, Unit id #1 unit id #3 unit id #2 unit id #4
E L A N H O M E S Y S T E M S
Page 10
© ELAN Home Systems 2006 • All rights reserved.
V883
INSTALLATION MANUAL
©
DIP Switch Settings - UNIT ID
Consult the chart below to determine the correct UNIT ID DIP switch settings. These
settings determine which output commands a particular unit responds to. V883s set
to UNIT ID 1 will respond to commands specifying Outputs 1-8, UNIT ID 2 responds
to commands specifying Outputs 9-16, etc.
Unit ID
Zones
Switch #1 (left)
Switch #2 (center)
1 (Factory Default)
1-8
OFF/UP
OFF/UP
2
9-16
OFF/UP
ON/DOWN
3
17-24
ON/DOWN
OFF/UP
4
25-32
ON/DOWN
ON/DOWN
1 2 3
UNIT 1
UNIT ID
1 2 3
UNIT 2
UNIT ID
1 2 3
UNIT 3
UNIT ID
1 2 3
UNIT 4
UNIT ID
(Factory Default)
Front Panel Unit ID Designations
The Output/Input LED indicators on the front panel display the V883’s Unit ID
designation. A decimal point located in the display window indicates the Unit ID
for each chassis as shown below.
Unit
ID #1
Unit
ID #3
Unit
ID #2
Unit
ID #4