E-Z-GO 602080 - Manual (Page 19)

OPERATION AND SERVICE INFORMATION
Page 3 Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
CONTROLS & INDICATORS
SERVICE BRAKE PEDAL
The service brake is a hydraulic front disc/rear drum
brake system.
Push foot operated service brake pedal to activate wheel
brakes, slowing or stopping vehicle (Ref. Fig. 2 on page
3).
PARKING BRAKE
Drive vehicle with park brake fully
released. Failure to do so will prema-
turely wear rear brakes.
The park brake is a mechanical system using rear drum
service brakes.
To engage, pull park brake handle up. An indicator light
will illuminate in gauge cluster reminding operator to
release park brake before driving (Ref. Fig. 3 on page 3).
To disengage, pull up slightly and push in release button
at end of handle, then fully lower park brake handle.
CHOKE
Starting a cold engine may require use of choke. To use,
pull choke knob out and hold while starting engine (Ref.
Fig. 4 on page 4). Once started and engine begins to
warm, release choke knob.
Do not allow starter to operate continu-
ously for more than 10 seconds. Allow
30 seconds between starting attempts. If vehicle does not start
on third attempt, turn key switch off, set park brake and deter-
mine cause of problem.
IGNITION SWITCH
Ignition switch has three positions: ‘OFF’, ‘ON’ and
‘START’ (Ref. Fig. 5 on page 4).
Insert key into switch and turn clockwise to ‘ON’ to
enable starting system.
Continue to turn clockwise to “START” to activate starter.
Once engine starts, release key allowing return to ‘ON’.
To prevent inadvertent operation of vehicle when left
unattended, turn key to ‘OFF’ position and remove key.
Fig. 2 Service Brake Pedal
Ref Sbp 1
Fig. 3 Park Brake and Indicator
Front of Vehicle
P
HOURS
8 16 0 4/4
Ref Pbh 2