Lifting the vehicle, Fig. 23 lifting the vehicle, Fig. 24 recommended oil – E-Z-GO 602080 User Manual

Page 33: Operation and service information, Owner’s manual and service guide

Advertising
background image

OPERATION AND SERVICE INFORMATION

Page 17

Owner’s Manual and Service Guide

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

LIFTING THE VEHICLE

Tool List

Qty. Required

Floor jack .................................................................... 1

Jack stands ................................................................. 4

Chocks ........................................................................ 4

To prevent possible inju-
ry o r d e at h re su lt in g
from vehicle falling off

jack, be sure vehicle is on a firm and level surface.
Never get under vehicle while it is supported by a
jack. Use jack stands and test vehicle stability on
stands. Always place chocks in front and behind the
wheels not being raised. Use extreme care since vehi-
cle is extremely unstable during lifting process.

To prevent possible injury or
death from operating engine

while vehicle is raised, disengage 4 wheel drive and
unlock front and rear differentials. To reduce possibil-
ity of vehicle damage:

Do not raise vehicle by placing jack under front or rear aluminum
differential cases.

Do not operate engine with 4 wheel drive or either differential
locks engaged.

Never operate engine with CVT drive belt removed.

Some servicing operations may require entire vehicle to
be raised (Ref. Fig. 23 on page 17).

Install chocks in front and behind each front wheel. Cen-
ter jack under flange on long axle tube. Raise vehicle and
locate a jack stand under outer ends of rear axle tubes.

Lower jack and test stability of vehicle on two jack
stands.

Center jack under front of frame. Raise vehicle and posi-
tion jack stands under frame as shown.

Lower jack and test stability of vehicle on four jack
stands.

Lower vehicle by reversing lifting sequence.

OIL

Use detergent motor oil designed for 4 stroke engines.

The oil must be of high quality and meet API SF, SG
standards.

For most conditions, 10W30 oil is recommended (Ref.
Fig. 24 on page 17).

See chart for viscosity allowed in extreme temperatures
(Ref. Fig. 24 on page 17).

!

!

Fig. 23 Lifting the Vehicle

Fig. 24 Recommended Oil

Ref Liv 5

View From Underside of Vehicle

-20

0

20

40

60

80

100

-30

-20

-10

0

10

20

30

40

C

F

0

30

30

(Air Temperature)

10W-30

10W-30

5W-30

5W-30

0

Ref Ovc 3

Advertising