ELSA Cable - Manual (Page 29)

Configuration modes
ELSA MicroLink Cable
21
English
What's happening on the line?
Trace Outputs
Trace outputs may be used to monitor the internal processes in the cable modem during
or after configuration.
The trace outputs are slightly delayed behind the actual event, but are always in the
correct sequence. This will not usually hamper interpretation of the displays but should
be taken into consideration if making precise analyses.
How to start a trace
The command to call up a trace follows this syntax:
trace [code] [parameters]
The trace command, the code, the parameters and the combination commands are all
separated from each other by spaces. And what is lurking behind the code and
parameters?
This code ... ... in combination with the trace causes the following:
? Displays a help text
+ Switches on a trace output
- Switches off a trace output
# Switches between different trace outputs (toggle)
no code Displays the current status of the trace
This parameter ... ... brings up the following display for the trace:
Status Status messages for the connection
Error Error messages for the connection
IP router IP routing
IP-RIP IP Routing Information Protocol
ICMP Internet Control Message Protocol
ARP Address Resolution Protocol
Masquerade Processes in the masquerading module
DHCP Dynamic Host Configuration Protocol
This combination
command ... brings up the following display for the trace:
All All trace outputs
Display Status and error outputs