ELSA Cable - Manual (Page 97)

Description of the menu options
ELSA MicroLink Cable
R89
Name Here you can enter the device name (maximum 16 characters). The set of characters
available includes uppercase and lowercase letters as well as some special characters.
You can display the full range of available characters during a configuration session by
entering the following command:
set \setup\name ?
In the default configuration, no name is entered.
Setup/Cable-module
This menu groups together all the settings necessary for starting up the interface to the
cable network and for the connection to the headend.
These settings should only be changed by the cable network operator, as operation
within the cable network will be impossible otherwise. The relevant menu items are
therefore not covered in this documentation.
Setup/LAN-module
This menu item displays the connection values relevant for the local network. The menu
has the following layout:
This option allows you to display the router’s own Ethernet address. The value displayed
here was set at the factory and cannot be changed. The Ethernet address is displayed
as a 12-digit hexadecimal value, with the first six digits '00a057' standing for an ELSA
device.
IP-router-module IP router module settings
SNMP-module Settings for configuration via SNMP
DHCP-server-module DHCP server settings
Config-module Configuration module settings
/Setup System configuration
/LAN-module LAN settings
Connector Network connection
Node-ID MAC layer address of the device