Bushnell Prime Low-Glow Trail Camera Kit (Gray) - Manual (Page 7)

7
Inserting the SD Card
Insert the SD card (with the camera’s power switch in the OFF position) before
beginning to operate the camera. Don’t insert or remove the SD card when the
power switch is in the
ON position.
The Prime Trail Camera uses a standard SD (Secure Digital) memory card to save
photos (in .jpg format) and/or videos (in .avi format). SD and SDHC (High Capacity)
cards up to a maximum 32GB capacity are supported. Before inserting the SD card
into the card slot after opening the camera’s front cover, please make sure that the
write- protect switch on the side of the card is “off” (NOT in the “Lock” position). The
following describes how to insert and remove the SD card:
• Insert the SD card into the card slot with its label side upwards (see above). A
“click” sound indicates that the card is installed successfully. If the wrong side of the
card is facing up, you will not be able to insert it without force-there is only one
correct way to insert cards. If the SD card is not installed correctly, the device will
not display an SD card icon on the LCD in SETUP mode (the SD card icon displayed
after switching to SETUP mode will have a “lock” symbol inside it in it if the card is
locked). Formatting the SD card by using the
Prime Trail Camera “Format”
parameter before using it for the first time is recommended, especially when a card
has been used in other devices (see “Changing Menu Parameter Settings” for
details).
• To take out the SD card, just gently push in the card (do not try to pull it out
without pushing in first). The card is released from the slot and ready to be removed
when you hear the click. Be sure the camera’s power is switched OFF before
inserting or removing SD cards or batteries.