Epson EL 486UC - Manual (Page 37)

Post-SETUP Procedures
After you run SETUP for the first time, you may need to install
the operating system on your computer. See your operating
system manual for instructions.
Once you have installed your operating system, install any
software you plan to use. See your application program
manuals for instructions.
You may also want to install the optional extended video
drivers for some of your application programs. See Chapter 5
for more information.
Turning Off the Computer
Whenever you turn off your system, follow these steps:
1. Save your data and exit any application program you are
using.
2. Check the hard disk drive light and the diskette drive light(s)
to make sure they are not on. Do not turn off the computer
if a drive light is on, because you can damage the drive or
lose data.
3. Remove any diskette(s) from the diskette drive(s).
4. Press the power button to turn off the computer and then
turn off the monitor, printer, and any other peripheral
devices.
Setting Up Your System 1-21