Electrolux Shirt Finisher F4VA1 - Manual (Page 12)

12
5.5. MANUAL CONTROLS section
AIR Press once to start blowing. Press it again to stop blowing. In
order to have manual MIX press STEAM during the blowing
operation.
REPEAT CYCLE Repeats the cycle without further tensioning; this but-
ton is enabled only at end of the pressing cycle and only if the
MANUAL END mode is selected.
END CYCLE Ends the cycle immediately, interrupts all ongoing com-
mands, opens all clamps. When the MANUAL END mode is
selected, press this button to open the clamps at the end of
the cycle.
STEAM Keep pressed to steam the shirt.
BACK CYCLE Use this button to undo the last step in the dressing
sequence.
5.6. Operating MODE
The Mode section consists of 3 buttons with green LED.
To select a mode press the relative button: the green LED turns on.
5.6.1. Button
When the LED is ON: the side clamps (10 - Figure 4.3) close at
the beginning of the cycle and open automatically after the
time programmed in the H03 parameter (see table 5.2). This
mode is useful for thick fabric or low extraction, because closed
clamps may hinder proper drying of the area.
When the LED is OFF: the side clamps stay closed during the whole
cycle.
The button has no function if the side clamps are excluded (param-
eter H05 = 00).
5.6.2. Button
The MANUAL END function is utilized when it is necessary to verify
garment pressing quality at the end of a cycle.
When the MANUAL END function is active (the green LED of the but-
ton “MANUAL END” is on), the clamps remain are not released at
end of the cycle.
This allows to:
•
run another cycle by pushing REPEAT CYCLE
• manually steam and blow the garment with buttons AIR and
STEAM
• manually touch up the garment with the iron (if mounted on
your machine).
When the garment is properly finished, end the cycle and open the
clamps by pressing the “END CYCLE” button (in the “manual con-
trols” section).
Use of the control board
5.6.3. Button
The button is not active.
F4VA1-ed3605
F4VA1