Electrolux Shirt Finisher F4VA1 - Manual (Page 15)

15
Figure 7.3 - Self diagnosis example
7. Troubleshooting
Refer to Table 7.4 for solutions to the most common malfunction situ-
ations.
If the proposed solutions do not work, enter self-diagnosis (para-
graph 7.1) to determine if there are failed components.
WARNING - DO NOT SERVICE THE MACHINE YOURSELF
Call the service center in any of the following cases:
• the machine has a problem that is not listed in table 7.4
• none of the remedies proposed by the table work
• control board self-diagnosis shows one or more failures.
7.1 Control board self-diagnosis
The control board is equipped with a self-diagnosis software that can
detect common problems to the pneumatic circuit.
1.
To enter self-diagnosis mode, press and together for two
seconds. The letter “C” appears on the PROG display.
2. Press button once. The letter F appears on the PROG dis-
play. The other displays (STEAM, MIX/ PAUSE, AIR) show infor-
mation concerning the status of the pneumatic circuit:
•
If there is no failure, the displays show: F -- -- --
• If there are failures, the display STEAM shows the number
of failures occurred (use + or – to scroll all the referenc-
es). The display MIX/PAUSE shows the code of the failed
component. The display AIR shows the code of the type of
failure.
Failure references are displayed using the codes in tables 7.1 and
7.2.
Figure 7.3 shows an example:
The pneumatic circuit has more than one failures.
The displays show information regarding failure number 2: the back
clamp solenoid valve has no power.
To erase faults memory, press PROG until the displays
show: F -- -- --
To exit self-diagnosis program, press and together until the
displays STEAM, MIX, PAUSE, AIR show pressing times.
Table 7.1
Number displayed
in the Air display The following fault has occurred
00 Neutral and phase are inverted
01 No power to the component
02 Short circuit at the component
Table 7.2
Number in the
Mix Pause dis-
play The following component has failed
06 Solenoid valve E7 - Sleeve arms relaxation
07 Solenoid valve E5 - Open front clamp
08 Solenoid valve E6 - Sleeve arms positioning
09 Solenoid valve E4 - Front clamp side move-
ment
10 Solenoid valve E3 - Rear clamp
11 Coil of remote control switch VT2 - Suction
motor
12 Solenoid valve E2 - Suction
13 Solenoid valve E1 - Collar clamp
14 Coil of remote control switch VT1 - Blower
motor
15 Solenoid valve E11 - Cuff clamp right
16 Steam valve E12
17 Solenoid valve E10- Cuff clamp left
21 Solenoid valve E14 - Carriage down
22 Solenoid valve E13 - Carriage up
23 Solenoid valve E8 - Side clamps
24 Solenoid valve E17 - Open side expanders
28 Solenoid valve E26 - Sleeve arms counter-
pressure
Troubleshooting
F4VA1-ed3605
F4VA1