EnGenius Technologies SHOPMASTER 28-248 - Manual (Page 11)

11
SINGLE PHASE (MODELS 28-248F & 28-348F) & THREE PHASE (MODELS 28-248G & 28-248G)
NOTE: The single phase LVC box comes with a connected power cord. The three-phase LVC box does NOT come
with a power cord.
1. Loosen, but do not remove the three screws (A)
Fig. 1 on the back of the LVC box.
2. Insert the power cord (single phase only) through
the hole (C) Fig. 2 from inside the cabinet.
3. Insert the three screws on the back of the LVC box
(A) Fig. 1 into the three holes (B) Fig. 2 on the inside
of the cabinet. Push down on the box to engage
the screws in the slots to secure the box.
4. Tighten the three screws (A) Fig. 3 from the outside
of the cabinet to hold the LVC box in place.
MOUNTING AN LVC BOX TO THE CABINET
NOTE: Attach both the single phase model and the three-phase model according to the following instructions.
C
A
Fig. 7C
Fig. 7B
Fig. 7A
A
B