EnGenius Technologies SHOPMASTER 28-248 - Manual (Page 13)

13
ATTACHING THE DOOR TO THE STAND
1. Align the two holes in one of the male hinges (A) Fig. 14 with the two holes on the stand.
NOTE: Point the hinge “up” (Fig. 14).
2. From the inside of the stand, insert a #10-24 x 1/2" socket head cap screw through the hole in the stand, and
thread the screw into the hinge. Repeat this process in the other hole to secure the hinge.
NOTE: Hand-tighten the hardware for further adjustment.
3. Attach the other hinge.
4. Use a straight edge to align the two hinges (Fig. 15).
5. Tighten the four hinge screws securely.
6. Align the two holes in one of the female hinges (C) Fig. 16 with the two holes in the stand door (D).
NOTE: Point the hinge opening “down”.
7. Thread a #10-24 x 1/2" socket head cap screw through the hole in the door and into the hole in the hinge. Secure
the hinge with the other screw.
NOTE: Hand-tighten the hardware for further adjustment.
8. Secure the other hinge.
9. Use a straight edge to align the two hinges (Fig. 17).
10. Tighten the four hinge screws securely.
11. Slide the two female hinges (C) Fig. 18 on the door over the two male hinges (A) on the stand.
12. The door latch is in one piece and snaps into the door. Insert the latch (A) Fig. 19 from the outside, through the
hole in the door.
13. Put pressure on the door latch to snap the latch in place.
14. To open the door, slide the latch away from the cabinet and pull the door.
C
D
C
A
Fig. 14 Fig. 15
Fig. 16 Fig. 17
Fig. 18 Fig. 19
A
A