EnGenius Technologies SHOPMASTER 28-248 - Manual (Page 17)

17
ATTACHING THE ON / OFF SWITCH TO THE STAND
1. Remove the two outer hex nuts and lock washers (A) Fig. 31 from the two screws on the back of the switch box (B).
2. Insert the two screws (C) Fig. 32 (located on the back of the switch box) into the two holes (D) in the band saw arm.
3. Use the two nuts and lockwashers (L) Fig. 33, removed in STEP 1, to fasten the switch box to the bandsaw arm.
4. Remove the screw and cable clamp (E) Fig. 34 from the lower arm of the band saw.
5. Insert the switch cord and power cord (F) Fig. 34 in the clamp (E) (removed in STEP 4), and fasten the clamp to the
bandsaw.
6. Insert the cord bushing into the hole (G) Fig. 35 on the top of the band saw stand.
7. Insert the switch cord (H) Fig. 36 through the cord bushing (G).
8. Insert the motor plug (J) Fig. 37 into the receptacle (H) of switch cord.
Position the motor plug (J) Fig. 37 and the switch cord (H) behind the dust chute (K).
NOTE: If you use the accessory height attachment with your saw, position the cords in front of the dust chute.
B
A
D
C
L
E
F
G G
H
J
H
K
Fig. 31 Fig. 32
Fig. 33 Fig. 34
Fig. 35 Fig. 36
Fig. 37