EverFocus 410H - Manual (Page 40)

(4) DURATION:
Buzzer noise and event record duration of an alarm, from 1 sec to 99 seconds. The default value is
5 seconds.
(5) ALARM OUTPUT:
The setting of alarms which are NONE and 1, where 1 means the alarm is enabled.
(6) ALARM EMAIL:
Select “YES ” for sending an email when alarm occurs. The email address can b e set in the
NETWORK SETUP MENU.
(7) BUZZER: Alarm buzzer.
ENABLE: To enable an alarm buzzer.
DISABLE: To disable an alarm buzzer.
(8) ALARM NETWORK:
YES: Enable alarm network.
NO: Disable alarm network.
(9) MAIN MON: Display on a main monitor when an alarm occurs.
NO CHANGE: Nothing changes on the display in the main monitor when an alarm occurs.
FULLSCREEN: A full screen will pop up when an alarm occurs.
(10) CALL MON: Display on a call monitor when an alarm occurs.
NO CHANGE: Nothing changes on the display in the call monitor when an alarm occurs.
SEQUENCE: Display in the sequence mode when an alarm occurs.
ACTIVE CAMERA: Display the active camera in full screen mode to the call monitor.
(11) SUMMARY :
Dial Jog to change items in the SUMMARY table.
All alarm’s statuses are shown in SUMMARY tables. These tables are for checking alarm
overall statuses, but not for setting.
Note : Please check APPENDIX C to see other available alarm input / output functions.
38