EverFocus 410H User Manual
Page 77
75
Search from EVENT LIST:
I.
Select Event Type from Alarm, Motion and Vloss.
II.
Press Update button to refresh the event list.
III.
All events of the selected type will be displaying along with Date/Time,
event type (represents by a capital letter), camera number (represents by a
number), e.g. M02 is the motion event from camera 2.
IV.
Current page and total page are shown below the event list. Press |<< for
first page, << for previous page, >> for next page, >>| for last page, or
simply input the page number, then press GO .
V.
Press Play button to playback the selected event.
Search by Time:
Search the starting date and time by entering Year/Month/Date/Hour/Min/Sec of
the happening event. Then press Play button to playback.
Playback by PTZ CONTROL:
I.
Select the PTZ camera from drop-down menu.
II.
Select Action Mode. 4 options are available: Continuous, Step x10, Step
x5 and Step x1.
III.
Use Direction Arrows (up, down, left, right) to move/adjust the focus to your
desired direction and angle.
IV.
Press Z+ for Zooming In or Z- for Zooming Out.
V.
In Focus option, press Near to move the focus closer to the subject. Or
you can move the focus farther from the subject by pressing Far .
VI.
You can turn on the Iris by pressing Open or turn it off by pressing Close .
VII.
“Preset” helps you to define the preset point at which you would like to see
the subject. Press Set for confirmation, Clear to exit or Jump to jump to a
specific point.
VIII.
“Auto Pan” is to define the speed of PTZ camera when moving horizontally,
please select from Lower, Low , Middle, High to Higher . Press Run
for confirmation or Stop to exit.