Extreme Networks Icron WiRanger - Manual (Page 17)

User Guide
11
NOTE : If the Pair/CH button is not pressed for 60 seconds the LED’s
will return to their normal operation and no changes will be
made to the current channel selection.
NOTE : If wireless communication is present it will continue until a
channel change is confirmed.
5. Once the desired 802.11g Radio Channel is displayed, press and
hold the Pair/CH button for 10 seconds. The button can be released
when the Host, Link and Activity LED’s start to blink rapidly.
NOTE : If the LED’s do not start blinking rapidly within 20 seconds
release the button and confirm that the LED pattern still
shows your desired channel pattern. If it does, repeat step 5.
If it does not, return to step 4.
6. Upon release of the Pair/CH button the LED’s will continue to blink
for approximately 20 seconds while the Channel Change is stored
and the 802.11g radio reboots. Once the blinking stops the Channel
Change is complete.
NOTE : DO NOT remove power while LED’s are blinking.
NOTE : If the channel selection on the LEX unit and the REX unit
are no longer the same the USB traffic will now stop. If the
channel selection on the LEX and REX are made the same
the USB traffic will begin.
7. If only one side of the system has been changed repeat steps 1 to 6
for the other side of the system. If channel selection is complete on
both sides of the system go to step 8.
8. Connect a USB cable between the WiRanger and the host PC, and
confirm its operation by checking if it is listed in Device Manager
(for Windows installations), or System Profiler (for Mac OS X
installations) under Universal Serial Bus controllers as a “Generic
USB Hub”.