EPoX Computer EP-3VCA2 - Manual (Page 60)

Appendix EP-3VCA2
A-8
5. Program parity according to Setup setting.
6. Power Management Initialization.
-
Enable/Disable global PM.
- APM interface initialization.
53 1. If it is NOT a PnP BIOS, initialize serial & parallel ports.
2. Initialize time value in BIOS data area by translate the
RTC time value into a timer tick value.
60 Setup Virus Protection. (Boot Sector Protection) function
ality
according to Setup setting.
61 1. Try to turn on Level 2 cache.
Note: If L2 cache is already turned on in POST 3D, this
part will be skipped.
2. Set the boot up speed according to Setup setting.
3. Last chance for Chipset initialization.
4. Last chance for Power Management initialization.
(Green BIOS only)
5. Show the system configuration table.
62 1. Setup daylight saving according to Setup value.
2. Program the NUM Lock, typematic rate & typematic
sp eed according to Setup setting.
63 1. If there is any changes in the hardware configuration,
update the ESCD information. (PnP BIOS only)
2. Clear memory that have been used.
3. Boot system via INT 19H.
FF System Booting. This means that the BIOS already pass the
control right to the operating system.
B-2 Unexpected Errors:
POST (hex) DESCRIPTION
B0 If interrupt occurs in protected mode.
B1 Unclaimed NMI occurs.0