1 installing a brim-e6 in a mim, Power-down your mmac hub, Disconnect all cables from the mim. note the po – Enterasys Networks BRIM-E6 User Manual
Page 15: Unscrew the top and bottom knurled knobs of the, Slide out the mim, and place it on its side wit, Remove the brim coverplate screws and the brim, Figure 2-1. removing the coverplate
Advertising
CHAPTER 2:
INSTALLATION
Page 8
BRIM-E6 USER’S GUIDE
2.2.1
Installing a BRIM-E6 in a MIM
To install a BRIM-E6 in a MIM that supports BRIM technology (e.g.,
EMM-E6 or ESXMIM):
Note:
We recommend that you power-down your hub even though
Cabletron MIMs have “hot swap” capabilities.
1.
Power-down your MMAC hub.
2.
Disconnect all cables from the MIM. Note the ports to which these
cables attach.
3.
Unscrew the top and bottom knurled knobs of the MIM face plate.
4.
Slide out the MIM, and place it on its side with the internal
components facing up.
5.
Remove the BRIM coverplate screws and the BRIM coverplate.
(See Figure 2-1.)
Figure 2-1. Removing the Coverplate
Coverplate
Standoff
Advertising