Windows xp/2000 users, Windows me users, Windows xp/2000 users windows me users – Edirol MA-1EX User Manual
Page 7: P. 7)
7
Getting Connected and Installing Drivers English
Windows XP/2000 users
*
In order to install software in Windows XP/
2000, you must log on as a user who has
administrative privileges (e.g.,
Administrator).
1.
With the MA-1EX disconnected, start up
Windows.
*
Disconnect all USB cables except for a USB
keyboard and USB mouse (if used).
*
Exit all currently running software
(applications).
*
If you are using a virus checker or similar
software, be sure to exit it as well.
2.
Use the USB cable to
connect the MA-1EX to
your computer, and
turn on the MA-1EX’s
power (turn the
VOLUME knob toward the right).
The MA-1EX (USB Audio) will be
detected automatically, and the driver
will be installed.
If you are using Windows XP, the installation
has been completed when the message near the
taskbar saying that
“Found New Hardware”
has disappeared.
942*
This unit is equipped with a protection circuit.
A brief interval (a few seconds) after
connecting a USB connector is required before
the unit will operate normally.
3.
Restart Windows.
Next, you need to make the driver
settings.
➔
Windows Me users
1.
With the MA-1EX disconnected, start up
Windows.
*
Disconnect all USB cables except for a USB
keyboard and USB mouse (if used).
*
Exit all currently running software
(applications).
*
If you are using a virus checker or similar
software, be sure to exit it as well.
2.
Use the USB cable to
connect the MA-1EX to
your computer, and
turn on the MA-1EX’s
power (turn the
VOLUME knob toward the right).
This unit is equipped with a protection circuit.
A brief interval (a few seconds) after
connecting a USB connector is required before
the unit will operate normally.
3.
Windows will detect the MA-1EX (USB
Audio), and the
“Add New Hardware
Wizard”
dialog box will appear.
Make sure that
Automatic search for a
better driver (Recommended)
is
selected, and click
[Next]
.
4.
Driver detection will begin.
5.
When the driver has been found, driver
installation will begin.
*
Depending on your system, a certain amount
of time may be required for the device to be
detected after the driver has been installed.
6.
Once the driver has been installed, a
dialog box will inform you of this.
Click
[Finish]
.
7.
Restart Windows.
Next, you need to make the driver
settings.
MA-1EX_efgis.book 7 ページ ２００５年１０月３１日 月曜日 午後２時３０分