Windows 98 users, P. 8) – Edirol MA-1EX User Manual

Page 8

Advertising
background image

8

Getting Connected and Installing Drivers English

Windows 98 users

*

The driver necessary for using the MA-1EX
with Windows 98 is provided on the Windows
CD-ROM. Make sure that you have the
Windows CD-ROM available.

*

Some computers are sold with the contents of
the Windows CD-ROM stored on the hard
disk, and therefore will not come with a
Windows CD-ROM. If this is the case for your
computer, you’ll be able to install the driver
even without the Windows CD-ROM.

*

The

USB composite device

driver is

installed first, then the

USB audio device

driver is installed. Use the following
procedure to install the drivers.

1.

With the MA-1EX disconnected, start up
Windows.

*

Disconnect all USB cables except for a USB
keyboard and USB mouse (if used).

*

Exit all currently running software
(applications).
If you are using a virus checker or similar
software, be sure to exit it as well.

2.

Use the USB cable to
connect the MA-1EX to
your computer, and
turn on the MA-1EX’s
power (turn the
VOLUME knob toward the right).

*

This unit is equipped with a protection circuit.
A brief interval (a few seconds) after
connecting a USB connector is required before
the unit will operate normally.

3.

USB composite device

will be detected

automatically, and the

“Add New

Hardware Wizard”

dialog box will

appear. Click

[Next]

.

4.

When

“What do you want Windows to

do?”

appears, select

“Search for the

best driver for your device
(Recommended)

,

and click

[Next]

.

fig.05-27e_30

5.

A dialog box like the one shown will
appear.
Check

CD-ROM drive

, and click

[Next]

.

*

If the display indicates

“Can’t find an updated

driver for this device

,

check

“Updated

driver

,

and click

[Next]

.

6.

A dialog box like the one shown will
appear.
Click

[Next]

.

*

Depending on your system, the

Driver

location

may differ from the illustration, but

this is not a problem.

7.

File (driver) copying will begin.

If the Windows CD-ROM is not inserted
in the CD-ROM drive, a “Insert Disk”
dialog box may appear. In this case, insert
the Windows CD-ROM into the CD-ROM
drive and click [OK].

MA-1EX_efgis.book 8 ページ 2005年10月31日 月曜日 午後2時30分

Advertising