Eiki LC-XB30 - Manual (Page 40)

40
Video Input
To store the adjustment data, move the red frame pointer to the
Store icon and press the SELECT button. The Image Level Menu
will appear. Move the red frame pointer to the Image Level 1 to 4
and then press the SELECT button. A confirmation box will appear
and then select [Yes].
Stored data can be called up by selecting "Image" in the Image
Level Selection on page 32.
Image Level Menu
Move the red frame pointer
to an image icon to be set
and then press the SELECT
button.
To reset the adjusted data, select Reset and press the OK button.
The confirmation box will appear and then select [Yes]. All
adjustments return to their previous figures.
Reset
Store
Exit the Image Adjust Menu.
Quit
Interlaced video signal can be displayed in a progressive picture.
Off . . . .Not activated.
L1 . . . . .Select “L1” for an active picture.
L2 . . . . .Select “L2” for a still picture.
Progressive
This function is effective on 3-2 pulldown video sources. With this
function On, the projector reproduces pictures faithful to the
original film quality.
Film
✔
Note:
• Progressive cannot be selected when 480p, 575p, 720p, 1035i, or 1080i is
selected. (p37)
• Film can only be activated when selecting NTSC for Video System and L1/ L2 for
Progressive and in any state shown below.
1. When selecting NTSC, NTSC4.43 PAL-M or 480i in the Video System Selection
(p37).
2. When selecting Auto and signal is NTSC, NTSC4.43, PAL-M(Composite) or
480i(Component) in the Video System Selection (p37).
• 3-2 Pulldown or Telecine transfer is the process of changing images from film mode
to video mode. While film runs at 24 frames per second (fps), NTSC television
signals (or video) have a run rate of 30fps so the 24 fps film needs to be speeded
up to 30fps and transferred using a proper field pattern to get the best film-like
images.
Store icon