Eiki LC-XT1 - Manual (Page 30)

LC-XT1
.
This Projector can automatically tune to the display signals from most personal computers
currently distributed. However, some computers employ special signal formats which are different
from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this
happens, the projector cannot reproduce a proper image and the image may be recognized as a
flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.
This projector has a PC ADJUSTMENT function to enable you to precisely adjust several parameters to match with those
special signal formats. This projector has 8 independent memory areas to memorize those parameters
manually adjusted. This enables you to recall the setting for a specific computer whenever you use
it.
NOTE: This PC ADJUSTMENT function cannot be operated when the input signal is digital from the DVI terminal or “RGB” is
selected on the SYSTEM MENU (P28 and 29).
1
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT RIGHT/LEFT button to
select PC ADJUST and press the SELECT button. Another
dialog box “Where to reserve” Menu will appear.
2
In this dialog box, you can store the parameter into the area from
“Mode 1” to “Mode 8.” When memorizing the new computer
parameter, select the Mode with the message “Free” by pressing
the POINT UP/DOWN button and the SELECT button. To
change
the parameters of the Mode previously set, select
the Mode with “Stored.”
3
When the Mode is selected, Parameter adjustment dialog box
appears. Move the arrow to the item that you want to
change by pressing the POINT UP/DOWN button, and adjust each
item by pressing the SELECT button to match with your computer.
4
Move the arrow to “Stored” and press the SELECT button.
The
parameter is memorized in the selected Mode.
5
To activate the Mode manually adjusted in this PC
ADJUSTMENT Menu, select the Mode at the SYSTEM
SELECT
Menu. (Refer to page 28.)