Ericsson WCDMA/HSDPA - Manual (Page 36)

Configuration and Management
The following configuration options are displayed on the DHCP server
page:
If this check box is selected the DHCP server is
working, otherwise it is turned off. Enable DHCP server
The first IP address in a range of IP addresses
that can be assigned to the LAN clients. IP address range
from
The last IP address in a range of IP addresses
that can be assigned to the LAN clients. IP address range to
The IP address lease time, specified in
seconds:
min: 60
max: 2147483647 Max Lease Time [sec]
To disable the DHCP server. Clear the Enable DHCP server check box on
the DHCP Server page.
If you for some reason want to configure your connected devices with static
addresses, make sure that the addresses are outside the DHCP server IP
address range.
To change the range of available addresses, change the IP addresses in
the IP address range from and IP address range to fields.
Note: The DHCP server IP address range has to be on the same subnet
as the Ericsson W20 LAN IP address. The IP address range must
not include the Ericsson W20 IP address. For instructions on how
to change the W20 IP address or subnet mask, see section
2.5 –
“LAN”.
In the Maximum lease time [sec] field, enter the time (in seconds) you
want the LAN device to lease the IP address before it is reassigned.
Click Apply to save the settings.
30 1/1551-CRH 102 167 PA15 2006-08-16