Eclipse - Fujitsu Ten CD5435 - Manual (Page 113)

113
Before installation
Before installation
Components
Installation angle
In order to maintain proper functioning, install the unit within an angle of 30
degrees from horizontal (standard). If this is not done, sound skipping or
ejection of the CD may occur.
● Note ●
Be sure to disconnect the vehicle battery's negative terminal
before installing the receiver.
No. Item Q'ty
1 Main unit 1
2 Mounting sleeve 1
3 Side bracket 2
4 Rear bracket 1
5 Bezel 1
6 Bushing 1
7 Self-tapping screw (6 x 16 mm) 1
8 Stud bolt 1
9 Flat head screw (red: 5 x 8 mm) 4
10 Hex-head bolt (red: 5 x 8 mm) 4
11 Hex-head bolt (6 x 20 mm) 1
12 Hex nut (5 mm) 1
13 Hex nut (6 mm) 1
14 Interconnecting cable 1
15 Remote control 1
FRONT
STANDARD
WITHIN AN ANGLE
OF 30 DEGREES
CD5435.book 113 ページ ２００４年１２月１１日 土曜日 午後５時２９分