Elmo HV-7000SX - Manual (Page 18)

17
5. OPERATION PROCEDURES
(1) Turn ON the power switch.
Notes: · Before turning ON the power switch, connection to
the monitor should have been completed.
· The indication lamp (green LED) on the front
operation panel shows the initial setting condition of
each function of the Presenter.
After the power switch is turned ON, the indication
lamp of the main camera only is illuminated.
· If the power switch is turned ON immediately after
being turned OFF, the Presenter may not operate.
For restarting, turn ON the power switch several
seconds after turning OFF.
(2) Place the object on the stage. Adjust the image size according
to the object size using the zoom buttons [TELE] and [WIDE]
on the operation panel or wireless remote control, while
watching the image on the monitor.
(3) Press the auto focus button [AF] on the front operation panel
or remote control for focusing.
Note: The auto focus function works up to a height of approx.
10 cm above the stage surface.
Front operation panel
Wireless remote control
Front operation panel
Wireless remote control
Simple steps for presenting printed material