Tv type setting, Tv display setting – Emerson Radio AV301 User Manual
Page 30
29
TV Display Setting
TV Display Setting
TV Display Setting
TV Display Setting
TV Display Setting
Path: Main Page
General Page
TV Display
Selects the aspect ratio of the TV set to be connected.
•
NORMAL/PS (4:3 Pan & Scan mode):Used when you
connect a normal TV to the system. Displays a wide picture
on the whole TV screen with a portion (right and left sides of
the picture) automatically cut off.
•
NORMAL/LB (4:3 Letterbox mode): Used when you connect
a normal TV to the system. Displays a wide picture with
bands displayed on the upper and lower portions of the
screen.
•
WIDE (16:9 Wide-screen mode): Used when you connect a
wide-screen TV to the system.
NORMAL/PS
NORMAL/LB
WIDE
Notes:
•
Some wide-screen discs that do not permit Pan & Scan mode
playback are automatically played in Letterbox mode.
•
Depending on the DVD, 4:3 Letterbox may be selected
automatically instead of 4:3 Pan & Scan and vice versa.
•
You must also set the screen mode on your wide-screen TV
to "FULL".
•
If WIDE is selected and a normal TV is connected, 16:9
content will appear distorted during playback (objects look
thin).
TV Type Setting
TV Type Setting
TV Type Setting
TV Type Setting
TV Type Setting
(Multi/ NTSC/ P
(Multi/ NTSC/ P
(Multi/ NTSC/ P
(Multi/ NTSC/ P
(Multi/ NTSC/ PAL)
AL)
AL)
AL)
AL)
If you live in North America your TV broadcast system is NTSC,
your TV set is either a NTSC TV or a multi system TV, and the
DVD movies you buy or rent will be labeled NTSC system.
The initial Default TV Type setting of this system is
"Multi". This setting will allow NTSC discs to play properly on
both NTSC TVs and multi system TVs. If you live in North
America no further adjustment is necessary. You can skip to
the next section.
If you wish to change the TV Type setting follow the 3 steps
below.
1 Press SETUP button to enter SETUP MENU. Use / to
select GENERAL SETUP (see page 27), and then press
ENTER button.
2 Highlight TV TYPE using / , then press
button to go to
the right option list. Select MULTI, NTSC or PAL using
/ , then press ENTER to confirm your selection.
3 Press SETUP again to exit SETUP MENU.
Note:
•
You can change the color system of the unit temporarily
without changing the Default setting by pressing the
N/P
(NTSC / PAL) button on the remote control. However when
the power is switched off, or the disc drawer is opened, the
TV type will automatically revert back to the initial Default
setting.
NORMAL / PS
NORMAL / LB
WIDE
MULTI
NTSC
PAL