Extreme Networks Px Series - Manual (Page 107)

Px Series Application Switch Installation and Configuration Guide 10-3
Showing Configuration Details
Showing Configuration Details
Table 10-2 lists the commands that are used to display configuration information.
Table 10-2: Configuration Display Commands
Command Description
show banner Displays the current startup banner message.
show config Displays the complete configuration to the screen.
show cookie Displays the current status of cookie processing. It is
disabled if no cookie processing is configured.
show default-gateway Displays the default gateway IP address for the Gigabit
Ethernet interface.
show dns-client Displays the domain name service (DNS) default domain and
the DNS server.
show gatewaymode [config] Displays the current gateway mode.
show gslb [config] Displays the activities of the GlobalPx Content Director
agent.
show healthcheck [config
| down | summary |
details | verbose] Displays the current health check configuration.
show iparp Displays the current layer 2 ARP table entries.
show iproute Displays the layer 3 forwarding database.
show natmode config Displays the currently configured NAT mode.
show proxy-ip Displays the currently configured proxy IP addresses.
show snmp Displays the current SNMP configuration.
show sticky [config] Displays which stickiness modes have been configured, and
the configured timer values.
show switch Displays the current version of software loaded in primary
and secondary flash, MAC addresses, and other useful
information.
show system-ip Displays the IP address of the Gigabit Ethernet interface,
along with its netmask.
show timeout Displays the TCP/IP timer settings.
show vlan Displays if VLAN support is enabled or not.
show vrrp [details |
autosync | config] Displays the current state of VRRP, including who is the
master and what the priorities are of each system.